Hobbywing FlyFun-100A-HV Bedienungsanleitung PDF herunterladen

Manual of Sensorless Brushless Speed Controller HW-SM002DUL-20130610

page 1

Thanks for purchasing our

Electronic Speed Controller (ESC). High power system for RC model can be very dangerous, so we

strongly suggest you read this manual carefully. In that we have no control over the correct use, installation, application, or

maintenance of our products, no liability shall be assumed nor accepted for any damages, losses or costs resulting from the use of

the product. Any claims arising from the operating, failure or malfunctioning etc. will be denied. We assume no liability for personal

injury, property damage or consequential damages resulting from our product or our workmanship. As far as is legally permitted, the

obligation to compensation is limited to the invoice amount of the affected product.

Features

1. Use extreme low resistance PCB to make the whole ESC with super current endurance capability.

2. Military quality capacitors with extreme low resistance increase the ability for preventing unwanted RF noise or interference.

3. Anti-spark circuit eliminates sparks when the battery pack is connecting with the ESC.

4. Protection features: Low-voltage cutoff protection / over-heat protection / throttle signal lost protection.

5. 3 start modes: Normal / Soft / Super-Soft, compatible with fixed-wing aircraft and helicopter.

6. Throttle range can be configured, fully compatible with all transmitters.

7. Smooth and accurate speed control, excellent throttle linearity.

8. Maximum speed: 210000 RPM (2 poles motor), 70000 RPM (6 poles motor), 35000 RPM (12 poles motor).

9. Pocket- sized program card can be purchased separately for extremely easy programming of the ESC at flying field.

Specification

Wiring Diagram

Note

: There are 2 control wires on the HV controller. The longer one is close to the positive battery wire, which is connected with the receiver,

and the shorter one is close to the negative battery wire, which is used to connect the program card to set the programmable parameters of the

controller.

Anti-Spark Circuit

There is a pair of bullet connectors and a thin red wire attached with the positive input wire (red color, thick) of the ESC. They are used to

eliminate sparks when the battery pack is connecting with the ESC. Please use it in the following sequence:

1. Disconnect the bullet connectors on the positive input wire (red color, thick) of the ESC.

2. Connect battery wires to the ESC.

3. Connect the bullet connectors on the positive input wire (red color, thick) of the ESC as soon as you hear the special tone ³ƈ´.

Feature Explanation

1. Brake

Brake Enabled / Brake Disabled, default is Brake Disabled

2. Battery Type

Li-xx(Li-ion or Li-po) / Ni-xx(NiMh or Nicd)ˈdefault is Li-xx.

3. Low Voltage Protection Mode(Cutoff Mode)

Soft Cutoff (Gradually reduces the output power) or Hard Cutoff (Immediately stops the

output power), default is Soft Cutoff.

4. Low Voltage Protection Threshold(Cutoff Threshold)

Low / Medium / High, default is Medium.

 For Li-xx batteryˈthe cells quantity of a battery pack is calculated automatically or set manually. Low / Medium / High cutoff voltage

for each cell is: 2.6V/2.85V/3.1V. For example: 10 cells Lipo, when ³0edium´ cutoff voltage is set, the cutoff voltage is:

2.85*10=28.5V.

 For Ni-xx battery, low / medium / high cutoff voltages are 0%/45%/60% of the startup voltage (i.e. the initial voltage of the charged

battery pack), 0% means the low voltage protection function is disabled. For example:20 cells NiMH battery, fully charged voltage is

1.44*20=28.89ZKHQ³0HGLXP´YDOXHLVVHWWKHFXWRIIYoltage is: 28.8*45%=12.96VǄ

5. Start Mode

Normal /Soft /Super-soft, default is Normal startup.

Normal is suitable for fixed-wing aircraft. Soft and Super-soft are suitable for helicopter. The initial speed of Soft and Super-soft mode is

very slow so it will take 3 seconds (Soft startup) or 6 seconds (Super-soft startup) from zero speed to full speed. But if the startup process

is completed (i.e. The motor is running), then the throttle is closed (that means the throttle stick is moved to bottom position at 0% throttle)

and opened again (throttle stick is moved upwards) within 3 seconds, the restart will be temporarily changed to normal mode to get rid of

the chances of crash caused by slow throttle response in aerobatic fly.

6. Timing

Low / Medium / High, default is Low.

In normal cases, Low or Medium timing is suitable for most motors. In order to get higher speed, please try the High timing value.

Note: After you changing the timing setting, please test your RC model on ground before taking off.

Begin To Use The New ESC

Note: ,QWKH IROORZLQJ LQVWUXFWLRQV ZH XVHWKH ZRUGVRI ³7RS SRVLWLRQ´DQG ³%RWWRPSRVLWLRQ´ WR represent the position of the

throttle stick.

Top Position: The throttle value is 100% at this position.

Bottom Position: The throttle value is 0% at this position.

Before using your new ESC, please check all the connections to make sure that they are reliable, and then start up the ESC in the following

sequence:

1. Move the throttle stick to bottom, and then switch on the transmitter.

2. Connect the receiver battery pack (4-6V) to the receiver, and then connect the main power battery pack to ESC, the ESC begins the

self-WHVWSURFHVVDQGWKHPRWRUZLOOHPLWVHYHUDO³EHHS´WRQHVWRrepresent the cells quantity of the lithium battery pack. After 2 seconds a

ORQJ³EHHS------´WRQHHPLWs, which means the self-test is OK, and now the RC model is ready to take off.

 If nothing is happened, please check your battery packs and all the connections;

 ,IDVSHFLDOWRQH³

´HPLWs after 2 beep tones (beep-beep-), means the ESC has entered the program mode, i.e. the throttle

channel of your transmitter is reversed, please set the direction of throttle channel correctly.

 ,ID YHU\ UDSLG ³EHHS-beep-, beep-beep-´ WRQH HPLWs 7KH WLPHLQWHUYDO RIHDFK ³EHHS-beep-´ WRQHLV  VHFRQGPHDQV WKH LQSXW

voltage is too low or too high, please check the battery voltage.

3. VERY IMPORTANT! %HFDXVHGLIIHUHQWWUDQVPLWWHUKDVGLIIHUHQWWKURWWOHUDQJH\RXQHHGWRXVHWKH³7KURWWOH5DQJH6HWWLQJ)XQFWLRQ´WR

calibrate the throttle range. Please read the instructions on page 1------³7KURWWOH5DQJH6HWWLQJ´

Alert Tone

1. Input voltage abnormal alert tone: The ESC begins to check the voltage of battery pack when it is power on, if the voltage is not in the

acceptable range, such an alert tone emits ³EHHS-beep-, beep-beep-, beep-beep-´ (YHU\ ³EHHS-beep-´ KDV D WLPHLQWHUYDO DERXW 

second)

2. 7KURWWOHVLJQDODEQRUPDODOHUWWRQH:KHQWKH(6&FDQ¶WGHWHFWWKHQRUPDOWKURWWOHVLJQDOVXFKDQDOHUWWRQHHPLWs³EHHS-, beep-, beep-´

(YHU\³EHHS-´KDVDWLPHLQWHUYDODERXWVHFRQGV

3. Throttle stick is not at its bottom position alert tone: When the throttle stick is not in the bottom (lowest) position, a very rapid alert tone

emits³EHHS-, beep-, beep-´(YHU\³EHHS-´KDVDWLPHLQWHUYDODERXWVHFRQG

Protection Function

1. Start up protection: If the motor failed to start up in 2 seconds, the ESC will cut off the output power. In this case, the throttle stick MUST be

moved to bottom again and then to restart the motor. (Such a situation happens in the following cases: The connection between ESC and

motor is not reliable, propeller is blocked, gearbox is damaged, etc.)

2. Over-heat protection: When the temperature of ESC is higher than a factory-preset value, the ESC will gradually reduce the output power.

3. Throttle signal lost protection: The ESC will reduce the output power if the throttle signal is lost for 1 second, further lost for totally 2

seconds will cause its output to be completely cut off.

Normal Startup Procedure

Please note that we use a special way to represent the cells quantity of a lithium battery pack: 1 ORQJ³EHHpü´= 5 short ³beep-´.

For example, 2 long ³EHHpü´ plus 2 short ³EHHp-´ (BeepüBeepüBB) means a 12 cells lithium battery pack, 1 long ³EHHpü´ plus 1 short

³EHHp-´ (BeepüB) means a 6 cells lithium battery pack, and so on.

Throttle Range Setting

Throttle range should be reset when a new transmitter is being used

Trouble Shooting

Trouble Possible Reason

Action

$IWHU SRZHU RQ PRWRU FDQ¶W ZRUN QR

sound is emitted

The connection between battery

pack and ESC is not OK

Check the power connection.

Replace the connector.

$IWHU SRZHU RQ PRWRU FDQ¶W ZRUN VXFK

an alert tone emits:

³EHHS-beep-, beep-beep-,beep-beep-´

(YHU\ ³EHHS-beep-´ KDV D WLPH LQWHUYDO

about 1 second)

Input voltage is abnormal, too high

or too low

Check the voltage of battery pack

$IWHU SRZHU RQ PRWRU FDQ¶W ZRUN VXFK

an alert tone emits:

³EHHS-, beep-, beep- ´(YHU\³EHHS-´KDV

a time interval about 2 seconds)

Throttle signal is abnormal

Check the receiver and transmitter

Check the cable of throttle channel

$IWHUSRZHURQPRWRUFDQ¶WZRUNVXFKD

alert tone emits:

³EHHS-, beep-, beep-´(YHU\³EHHS-´KDV

a time interval about 0.25 second)

Throttle stick is not in its bottom

position (Lowest position).

Move the throttle stick to bottom

Size

Lipo NiMH L*W*H

80A

FLYFUN-80-HV 80A 100A 5-10 15-30 Yes 125g 88*55*18

100A

FLYFUN-100-HV 100A 120A 5-12 15-36 Yes 112g 88*55*18

Battery Cell User

Programmable

BEC Output

N/A

Class

Model Cont.

Current

Burst Current

(>10s)

Weight

Switch on the

transmitter, and

then move the

throttle stick to

bottom position

Connect the battery

pack to ESC, a

special tone ³

123´

will emits, means the

power supply is OK

When self-test is

finished, a long ³beep

ü´ tone emits

Ready to go

flying now

Several ³beep-´ tones

emit to represent the

cells quantity of the

lithium battery pack

Switch on the

transmitter,

and move the

throttle stick

to top position

Connect the

battery pack to

the ESC, and

then wait for

about 2 seconds

³Beep-beep-´ tone

emits, which means

the highest point of the

throttle range has been

correctly confirmed

Move the throttle stick to the

bottom position, and then

several ³beep-´ tones emits to

represent the number of Lipo

battery cells

A long ³Beep-´ tone emits,

means the lowest point of

the throttle range has

been correctly confirmed.

1 2

Inhaltsverzeichnis

Seite 1

Manual of Sensorless Brushless Speed Controller

Seite 2

Manual of Sensorless Brushless Speed Controller

Kommentare zu diesen Handbüchern

Keine Kommentare

Hobbywing FlyFun-100A-HV Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Zubehör für die Luft Hobbywing FlyFun-100A-HV herunter. Hobbywing FlyFun-100A-HV User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Zubehör für die Luft Hobbywing FlyFun-100A-HV